Step 1: Melt Wax Two Ways to Melt The Wax:
1. Add 20m of water to the measuring cup. Put the paper cup on top of it. Microwave it for 60-90s.
2. Add 60ml hot water to the measuring cup. Put the paper cup on top of it till the wax fully melts. (Normally takes 2-3 minutes)
Actual heat times may vary depending on your heating methods and wax beads amount.
Step 2: Dip The Wax Dip the nose applicator into the wax and rotate in the melted wax to gets the appropriate amount of wax. Do not dip deeper than the base of the collar.
Before proceeding, test wax temperature by placing a small amount on the inside of your wrist.
Step 3: Insert Applicator Please use the Moustache Protective Sticker to prevent waxes from pasting mustaches.
Insert the applicator into the nose and the collar should be outside the nostril. Press the nose lightly for a better grip, do not move or twist the applicator,
Wait for about 1~2 minutes, but not more than 2 minutes.
Step 4: Pull Out Holding your nose tightly with one hand and pulling down the applicator with another hand in a swift movement, as quickly as possible.
Do not be slow as this will cause tugging of the hair.